How to Reset Canon IP 2770 Error 5200

This printer is a printer is economical and widely used in homes and offices. This printer did not escape from the various errors that occur. Even the few conversations this printer cyberspace. Despite the many blogs or websites that talk about How to Reset Canon IP 2770 Error 5200, it would not hurt if I go back to review.

Ok. just on the points above.
Initial indications:
When the printer is turned on, the printer looks normal with GREEN LED flame. But after trying to print, the printer suddenly stops and error 5200 appears on the screen. Blinking and the printer will run with 8x orange, and green 1x.

How is the next step?

• The first way:. 

Replace the color cartridge iP2770, then the 5200 error problem was resolved. This method is the easiest way but spend lots of money to buy new cartridges.

• The second way

1. The printer is off and plugged the power cord.
2.  Press the RESUME button two seconds. Then press the POWER button until the green light flame (when pressing POWER button, Resume button not released yet)
3. Then release the Resume button, but do not release the button POWER.
4. POWER button while still depressed, press the Resume button 5x. Led will flash alternately orange glow green with orange last. Caution: not to mistakenly press the resume button 4x, because the printer will die completely, but it is temporary as well) Then ...
5. Release both buttons simultaneously.
6. Led will blink briefly then will glow GREEN.
7. And the computer will detect new hardware, ignore it ...
8. Press the POWER button, then the printer will die.
9. Press the POWER button again and then the printer will flame ... PRINTER iP2770 is ready to use.

•  The third way

1. Turn on the printer and the printer will look normal.
2.  Try the printer is made for printing documents or print test, then the 5200 error will appear.
3. Unplug the power cord without pressing the button on-off
4. Open and slide it into the cartridge manually (press the lock latch in the back of his white head, so that cartridges can be pulled into the middle)
5. Unplug all his cartridges and leave the lid open
6. Turn on the printer, hit the head will move to the left and right because the lid is still open and will stop in the middle.
7. Reinstall the cartridge, and close the right
8. Your printer will return to normal